Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3 Charging your devices
You have checked that the specifications of the power bank match the specification of your
D
device. Refer to the section "Technical data".
1. Connect a device to the power bank.
2. Press the power button to start charging.
3. Disconnect the charging cable when charging has completed.
Note:
– If the power bank overheats, the over-temperature protection function will automati-
cally stop charging/discharging and all 4 LED indicators will flash.
– Charging/discharging resumes when the power bank temperature drops to 10 °C be-
low the temperature protection limit.
8 Troubleshooting
Problem
Possible cause
Cannot charge a con-
Power bank battery is flat.
nected device.
Cannot charge the
The output voltage of the
power bank (LED indi-
power adaptor is too low.
cator is not flashing).
Faulty cable.
9 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect all devices from the power bank and the power bank from the power supply.
2. Clean the product with a dry, fibre-free cloth.
10 Disposal
This symbol must appear on any electrical and electronic equipment placed on the
EU market. This symbol indicates that this device should not be disposed of as
unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back
of waste. Conrad provides the following return options free of charge (more details on our
website):
in our Conrad offices
at the Conrad collection points
at the collection points of public waste management authorities or the collection points set
up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in
countries outside of Germany.
Suggested solution
Recharge the power bank.
Use a suitable power adaptor. See
section "Technical data".
Check the cable and connection.
Replace the cable if needed.
11 Technical data
11.1 Power supply
Rechargeable battery type ........... Lithium-ion
Capacity ........................................ 22400 mAh, 3.7 V, 82.88 Wh
Input port USB-C1 (USB-C
) ........ 5 V/3 A, 9 V/3 A,12 V/3 A, 15 V/3 A, 20 V/2.25 A
®
Output port USB-C1 (USB-C
) ..... 5 V/3 A, 9 V/3 A, 12 V/3 A, 15 V/3 A, 20 V/5 A
®
PPS: 3.3 V - 11 V/ 3A, 3.3 V - 21 V/3 A
Output port USB-C2 (USB-C
) ..... 5 V/3 A, 9 V/3 A, 12 V/3 A,15 V/3 A,
®
20 V/5 A, 28 V/5 A
(Qualcomm
Output port USB-A ....................... 5 V/3 A, 9 V/2 A, 12 V/1.5 A
(Qualcomm
Total output ................................... 163 W (USB-A and USB-C
Charging time (empty to full) ........ approx. 4.5 hours (with PD 30 W supply)
approx. 9 hours (with non-PD supply)
Recharge cycles ........................... >300 times
11.2 Other
Indicators ...................................... 4 LEDs
Protection ..................................... Short circuit, overcharge, over discharge, overheat
Operating conditions ..................... 0 to +35 ºC, ≤80 % RH (non-condensing)
Storage conditions ........................ 0 to +30 ºC, ≤80 % RH (non-condensing)
Dimensions ................................... 190 x 87.5 x 23.5 mm (L x W x H)
Weight .......................................... 550 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE.
Quick Charge
3.0 Technology)
®
TM
Quick Charge
3.0 Technology)
®
TM
)
®
*2633523_V1_1122_02_jh_m_en_(2)
Werbung
Inhaltsverzeichnis
