Siemens SINAMICS V20 Betriebsanleitung Seite 419

accordance with Clause 5.3, it shall also submit the CoL of the Source License to the third
party.
5.5 If the Licensee receives a data medium which, in addition to the SW, contains further
software products which are released for use, then it shall have the right to use these
released software products exclusively for validation purposes, for a limited period of time
and free of charge. The period of use shall be limited to 14 days, commencing with the first
start-up of the relevant software program unless a different period is specified e.g. in the
readme file of the relevant software product. These software products supplied exclusively
for validation purposes shall be governed, mutatis mutandis, by the stipulations contained in
these General License Conditions. The Licensee shall not be authorized to pass on these
software products separately, i.e. without the SW, to a third party.
The conditions of the purchase contract apply if not otherwise stipulated hereafter for the
Open Source Software.
2) License Conditions and Disclaimers for Open Source Software and other Licensed Software
In the product "SINAMICS V20", Copyright Siemens AG, 2015 (hereinafter "Product"), the
following Open Source Software is used either unchanged or in a form that we have
modified, and additionally the other License Software noted below:
Liability for Open Source Software
Open Source Software is provided free of charge. We are liable for the Product including
Open Source Software contained in accordance with the license conditions applicable to the
Product. Any liability for use of Open Source Software beyond the program flow intended for
the Product is explicitly excluded. Furthermore, any liability for defects resulting from
modifications to the Open Source Software by you or third parties is excluded.
We do not provide any technical support for the Product if it has been modified.
Availability of Source Code
Certain license conditions of third-party software components used in this product may
require Siemens to provide you with the source code and additional information for such
components. In most cases, Siemens provides this information on or with the device. In case
Siemens is technically unable to do so, you may request a copy of this information against
payment of shipping and handling charges. Please send your request to the address
provided at the end of this section.
Siemens AG
Digital Factory
Customer Services DF&PD
DF CS SD CCC TS
Gleiwitzer Str. 555
90475 Nuernberg, Deutschland
Internet: http://www.siemens.com/automation/support-request
Tel.: +49 911 895 7222
Email: support.automation@siemens.com
Umrichter SINAMICS V20
Betriebsanleitung, 05/2017, A5E34560031-007
Allgemeine Lizenzbedingungen
419