Bestway LAY-Z-SPA Bedienungsanleitung Seite 9

SAFETY INFORMATION
prevent unauthorized access to the spa by children. This can be reached by adult supervisor securing the
means of access or installing a safety protection device to the spa. To avoid accidents during spa use,
ensure that children are kept under constant adult supervision.
WARNINGS - SAFE WATER MAINTENANCE AND CHEMICAL USE
• Never add water to chemicals. Always add chemicals to water to avoid strong fumes or violent reactions
that may result in hazardous chemical spray.
• Regarding the information pertaining to cleaning, maintenance of water, and disposal of water, please
see the "MAINTENANCE" section.
• Do not use spa during chemical maintenance.
• Any manual dosing of chemicals shall not be performed while bathers are present in the spa.
• Consult your local government authority for water regulations related to convenient water supply for
filling the spa.
WARNINGS - SAFE SETUP AND STORAGE
• We strongly recommend not to unfolding and inflating the spa if the ambient temperature is below
15°C (59°F). We suggest inflating the spa indoors, and then continuing to setup outdoors. If the
outdoor temperature is lower than 6°C (42.8°F), the spa heater must always be on. In this mode, the
Freeze Shield system can keep the internal temperature between 6°C (42.8°F) and 10°C (50°F) to
®
prevent damage, such as water freezing in the pipes or the circulation system.
CAUTION: If alarms pop up on the spa, the Freeze Shield
the status of your spa if the outdoor temperature is below 6°C (42.8°F). In case of a long-term absence
from home when there is a risk of temperatures falling below 6°C (42.8°F), we strongly suggest
disassembling the spa and storing it following the storage procedure.
• When the appliance will be not used for a long time, such as in the winter, the spa or pool set should
be disassembled and stored indoors.
• Do not to place the spa on a slippery surface and make sure the surface is free of sharp objects
before installation.
• To avoid damage to the pump, the spa must never be operated unless the spa is filled with water.
• For safety reasons, only use the accessories provided or approved by the spa manufacturer.
• Regarding the information pertaining to the installation, refer to the following paragraph of the manual.
• Whenever the spa is emptied, the filter should be cleaned (and drained/dried, where applicable).
• Please examine equipment before use. Notify Bestway at the customer service address listed on this
manual for any damaged or missing parts at the time of purchase. Verify that the equipment
components represent the models that you had intended to purchase.
• This product is not intended for commercial use.
• Always keep the spa cover on to minimize heat loss during heating of the spa between uses (but not
while it is being used). Ensure the cover is fitted tightly, as per instructions to maximize insulation. It
shall be recommended that the cover, when not in use, should be kept off the ground to retain its
cleanliness (particularly the surface in close proximity to the water spa water surface). The cover
should be stored in an appropriate location, where it cannot be damaged, or cause damage.
• Check the set water temperature and consider lowering it for the times when the spa will typically
not be in use.
• Depending on external conditions, consider turning off the heater entirely if not using the spa for an
extended period of time (where the spa provides this option, but still maintains residual
disinfection/pH-values).
• It is recommended to use an insulating ground cloth underneath the spa to minimize heat loss through
the bottom of the spa.
• Maintain clean filters to preserve appropriate working conditions for the pump and avoid unnecessary
water replacement and re-heating.
• Keep the spa away from the rest area to minimize noise disturbance.
• Do not put the cover on the ground or any other dirty surface when not in place on the spa.
system will stop working. Be sure to check
®
9