Bestway LAY-Z-SPA Bedienungsanleitung Seite 12

SETUP INSTRUCTIONS
• To minimize these effects in an indoor environment, provide plenty of ventilation to the selected area.
Consult an expert to confirm the installation area is properly ventilated prior to use.
• To avoid home or property damage, only install the hot tub in an area with an adequate drainage
system. Water may flow out of the hot tub during filling, draining, or when in use.
OUTDOOR INSTALLATION:
Be aware of these special requirements if you install the hot tub outdoors.
• The selected surface must be clear of aggressive plants and weed species. Types of strong vegetation
could grow through the liner and create water or air leakage. Grass or other vegetation that may cause
odor or slime to develop must be eliminated from the chosen location.
• The selected location must not have overhead power lines or trees. Be sure the location does not
contain underground utility pipes, lines or cables of any kind.
• Do not leave the hot tub's surface exposed to direct sunlight for long periods of time. We recommend
protecting the hot tub from direct sunlight exposure with a cover when not in use.
• Consult a local professional installer for environmental conditions, such as ground water and risk of frost.
Follow the important requirements above to choose the correct surface and location to set up your hot tub.
NOTE: If parts become damaged because the set-up surface and location do not adhere to these
instructions, it will not be considered a manufacturer defect and will void the warranty and any service
claims. It is the owner's responsibility to ensure the site meets the requirements at all times.
ASSEMBLY INSTRUCTIONS
For installation instructions, scan the QR code printed on the front cover or follow the drawings printed
on the top of the package. Drawings are for illustration purposes only. May not reflect actual product.
Not to scale.
• Do not use an extension cord or multi-plug adapter with the hot tub heater as it is dangerous and can
cause the plug to overheat, potentially damaging the equipment and surrounding items.
• Place the hot tub away from the rest area to minimize noise disturbance.
• Keep at least 1 m (3 ft. 3 in.) of clearance around the hot tub.
• Do not use saltwater to fill the pool. High concentrations of salt can corrode the internal metal components.
• The filtration system of the hot tub is designed to only be used with the filter cartridge. Any other
component added inside the filter set can cause damage to the filtration system. This will not be
covered by the warranty.
NOTE: Before assembling the hot tub, lay the liner in the sun to help soften the material and make it
easier to set up.
INFLATION INFORMATION- FOR INFLATABLE HOT TUBS ONLY:
• When inflating, you will notice that air will be expelled from the area where the air hose connects to the
pump. This is normal.
• Do not cover the holes on the base of the inflation hose, the inflation hose is designed to inflate the hot
tub to the correct pressure. This will over-inflate the liner and damage the structure.
• Do not use an air compressor to inflate the hot tub.
• Do not drag the hot tub on rough ground as this may cause damage to the liner.
• Please inflate the hot tub when the outdoor ambient temperature is above 15ºC (59ºF).
FORTIFIBER™ DROP STITCH HOT TUBS ONLY:
Hand Pump Pressure Gauge
• The air pressure gauge on the hand pump only shows the air
pressure when it is higher than 5 PSI, which is normal.
• When the air pressure inside the hot tub is lower than 5 PSI,
the air pressure gauge will not show a value.
Air Valves
• If the air valve is loose, use the provided wrench to tighten it.
With one hand, hold the backside of the air valve from the inner
side of the hot tub wall and turn the wrench clockwise.
• Do not adjust the air valve connector when the hot tub is in use.
12