Silvercrest SNOT 1.5A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 37

the front area of your nostril or ear. Remove the nose
or ear hair with small circular movements.
After using switch the product off as described in the
chapter "Switch on/off".
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning agents.
These might damage the surface of the product.
Take the nose and ear hair trimmer attachment
3
off as shown in Fig. D and clean it carefully under
running water. Then fully dry the nose and ear hair
trimmer attachment before re-installation.
3
Attention: The product is only protected against splash
water. Never immerse it in water. Otherwise, irreparable
damage may result.
If there are still hairs in the blade clean it with the
4
cleaning brush .
8
Occasionally place one or two drops of oil onto the
blade and distribute the oil evenly (see Fig. C).
4
Only use an acid-free oil suitable for electric razor
products.
Wipe the housing with a dry cloth.
GB/IE 37