Silvercrest SMK 7000 B2 Bedienungs- Und Sicherheitshinweise Seite 18

control lamp lights up. The oscillation function
causes the discharged air to be distributed from
left to right.
4.5 Range of use of the remote control
When controlling with the remote control, please be
sure to observe the range of use of the device shown
below. To ensure that the unit responds to a button
press on the remote control, make sure that the re-
mote control is within the range of use shown when a
4.6 Empty water tank
Note:
If the room temperature is low and the humidity is
high, the product may not be able to evaporate
the moisture quickly enough. In this case, water
collects in the water tank.
If the product is in dehumidification mode "dh",
it extracts moisture from the room air. Conse-
quently, water accumulates in the water tank.
When the water tank is full, the "FULL" indicator
light lights up and the product stops operating.
button is pressed. Depending on the distance to the
unit, the angle of use and radius change, resulting
in the respective area of use. The most favourable
positioning of the remote control in relation to the
unit is in the centre at the height of the display 2 .
Note: If there are objects, walls or other obstacles
between the unit and the remote control, the control
of the unit with the remote control may be obstructed.
Follow the steps below to empty the water tank:
Switch off the unit and disconnect the mains
plug from the socket.
Remove the hose connector
outlet 9 and remove the hot air outlet hose
from the appliance.
To empty the water tank, use a shallow bowl
that can hold more than 0.5 l of water.
from the rear air
13
14
GB/IE/NI/CY/MT 17