Default Settings; Maintenance; Before Initial Operation - Cleco Neotek 30-Serie Bedienungsanleitung

Default Settings

LED Blue Green
Light
De- Tool Run- OK run-
scrip- ning down
tion
7

Maintenance

Implement a comprehensive safety maintenance program to provide regular inspection for all phases of tool operation
and power supply.
Note
Loss of warranty
Repairs are only permitted by Apex Tool Group authorized personnel. If the tool is opened, the warranty
is voided.
► If repair is required send the complete tool to Sales & Service Center!
Tool
All series
All 30/50 series
70 series Angle
70EAN155NA6
70EAN205NA6
70EAN240PA6
70EAN350PA6
70EAN500RA6
70EAN600SA8T
70EAN800TA8MT
70EAN1500TA8MT
70EAN2000TB8MT
70EAN4000UA12MT
70 series Inline
70ESN95ND6
70ESN130ND6
70ESR1302ZB
70ESN180ND6
70ESR1852ZB
70ESN245ND6
70ESR2453ZB
1
Use of 80 % of maximum torque.
Apex Tool Group
6
Red Yellow
Connect tool
► Connect the tool via tool cable to the controller (see
NOK run- User de-
down fined
Depending on which event oc-
curs earlier:
1
Time interval Cycles
Daily
36 months 1,000,000
36 months 1,000,000
36 months 500,000
24 months 250,000
36 months 1,000,000
36 months 500,000
TM12-1109 | REV G l 2023-09

Before Initial Operation

Quick Installation Guide).
Measures
► Check all connections.
► Visual inspection for general damage.
► Perform a general function test and watch
out for excessive vibration or unusual
noise.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
► Send the tool to a certified Sales & Ser-
vice Center for assessment.
1
EN
9