Electrical Data; Ambient Conditions; Troubleshooting - Cleco Neotek 30-Serie Bedienungsanleitung

1
EN
8.4

Electrical Data

Features
Supply Voltage, Single Phase
[VAC]
Rated Supply Current [A]
Frequency [Hz]
Peak Current [A]
Rated Power [max. VA]
Idling [VA]
Protection class nach
DIN EN 61140
8.5

Ambient conditions

Features
Operation site
Working temperature
Storage temperature
Type of cooling
Relative humidity
Working height
Degree of protection EN 60529
9

Troubleshooting

Problem
Tool does not start.
Tool not recognized.
Tool doesn't start with counter-
clockwise rotation activated.
16
Series 30, 50
100–240±10 %
2–1
50–60
16
1600
160
Protection separation
Data
Indoors
0 °C – 45 °C
-25 °C – 70 °C
Convection (self-cooling)
10 % – 90 %, no condensation
Up to 3000 m (9,843 ft) above sea level
IP40
Possible cause
Faulty start switch.
Faulty cable.
Bent pins in cable or tool.
Speed is not parameterized.
Controller is waiting for tool en-
ablement.
Self-identification data are not
recognized after tool change.
Software is incorrect.
Cable is defective.
Tool is defective.
With counterclockwise rotation,
parameter for speed is set to
1
0 /min.
TM12-1109 | REV G l 2023-09
Data
Series 70
230±10 %
50–60
1600
Protection separation
Measure
► Replace start switch.
► Replace cable.
► Straighten contact pins or replace faulty con-
nector.
► Check Linking group. In the mPro mode, se-
lect Navigator> Standard or Navigator> Basic.
► Enable the input Tool Enable or, if not re-
quired, deactivate Tool Enable.
Accept Tool Settings again:
1. Navigator > Tool Setup.
2. Select the line with the tool.
3. Select Tool Settings> Accept.
► Check controller software.
► Replace cable.
► Change tool.
Parameterize Speed left rotation
► Select on the controller Navigator > Stand-
ard > Tool Groups > Settings For Speed Left
Rotation.
2–1
7.0
160
Apex Tool Group