Measuring Program (435-2/-4 Only) - Testo 435 Bedienungsanleitung

52 6. Setting the instrument

6.2.2 Measuring program (435-2/-4 only)

A measuring program can be programmed and activated/deactivated:
Designation
Off
AUTO
Turb
Deactivating a a m m easuring p p rogram:
The main menu is open, Menu is displayed.
Meas.Prog
1
Press
2
- The instrument returns to measurement view.
Programming a a nd a a ctivating t t he A A UTO m m easuring p p rogram:
The main menu is open, Menu is displayed.
Meas.Prog
1
Press
2
The measuring cycle is set in the order: seconds/minutes/hours.
Press
3
.
OK
Perform the setting for minutes and seconds as described in step
4
Press
5
- The instrument returns to measurement view.
Activating t t he T T URB m m easuring p p rogram:
The measuring program for measuring turbulence is only available if a
turbulence probe is plugged in.
The main menu is open, Menu is displayed.
Meas-Prog
1
Press
2
- The instrument returns to measurement view.
Description
Measuring program switched off: Readings can be stored manually
Automatic measuring program: The measuring cycle (min. 1s) and the number of
readings can be set freely.
Automatic measuring program for measuring turbulence (only if a turbulence probe
is available and plugged in): The measuring cycle (1/5s) and duration (180s) are
preset.
.
OK
/ to select Off and confirm with
.
OK
/ to select AUTO and confirm with
/ to set the measuring cycle in seconds and confirm with
/ to set the number of readings and confirm with
.
OK
/ to select Turb and confirm with
.
OK
.
OK
.
OK
.
3
.
OK