Fly The X4; Power-On Safety Mode - Hubsan H107C Bedienungsanleitung

9 FLY THE X4

9.1 Power-On Safety Mode

Your X4's flight controller is designed with a Power-On safety feature that ensures that the
X4's motor will not start unless it detects a suitable control signal when the LiPo battery is
connected.
In order to get the copter ready for flying, observe the
following steps:
1. Make sure the flight battery sits securely in the
compartment.
2. Press the power button under the quadcopter.
3. Put the X4 on a level surface, or the X4 will drift.
4. Wait until the blue LEDs blink, and the red LEDs
are lit solid.
5. Power on the transmitter (ON/OFF switch) to start
pairing. The screen will show data.
- Do not move any other stick or trim before the
transmitter and X4 have finished pairing, or the
X4 will drift.
6. Pairing will be completed after one "Beep" heard,
and all LED indicators remain lit.
Low Battery Alarm: The two red
LEDs will blink quickly and the X4
will descend and land down
automatically to 5 meters or lower
from the takeoff point when the X4
battery is low.
www.hubsan.com
T R
X X
M1 M2
Expert
35
H107C+
THE HUBSAN X4