Braun ThermoScan 7+ connect Bedienungsanleitung Seite 9

How to change temperature between °C and °F
Your Braun ThermoScan® is shipped with the Celsius (°C) temperature scale activated. If you wish to switch to
Fahrenheit (°F) and/or back from Fahrenheit to Celsius, proceed as follows:
1. Make sure the thermometer is turned off .
2. Press and hold the Power button
display will show this sequence: °F / SET / °C / SET.
3. Release the Power button
is shown. There will be a short beep to confi rm the new setting, then the thermometer is
turned off automatically.
Errors and troubleshooting
Error message
and temperature button . After about 3 seconds the
and temperature button , when the desired temperature scale
Situation
No Hygiene cap is attached.
The thermometer probe was not positioned
securely in the ear.
An accurate measurement
was not possible.
ERROR + position error animated icon
Ambient temperature is not within
the allowed operating range
(10 – 40 °C or 50 – 104 °F).
Temperature taken is not within
typical human temperature range
(34 – 42.2 °C or 93.2 – 108 °F).
HI = too high
LO = too low
System error – self-check display fl ashes
continuously and will not be followed by
the ready beep and the ready symbol.
If error persists,
If error still persists,
Battery is low, but thermometer will still
operate correctly.
Battery is too low to take correct
temperature measurement.
System error without messages or
completely dead batteries
Unsuccessful connection.
Solution
Attach new, clean Hygiene cap.
Take care that the positioning of the probe is correct
and remains stable.
Replace Hygiene cap and reposition.
Press Start button to begin a new measurement
temperature.
Allow the thermometer to remain for
30 minutes in a room where
the temperature is between 10 and 40 °C
or 50 and 104 °F .
Make sure the probe tip and lens are clean and a
new, clean Hygiene cap is attached. Make sure the
thermometer is properly inserted. Then, take a new
temperature.
Wait 1 minute until the thermometer turns off
automatically, then turn on again.
... reset the thermometer by removing the batteries
and putting them back in.
... please contact the Service Centre.
Insert new batteries.
Insert new batteries.
Insert new batteries. If the error persists, call
customer service.
Check issue in the app for more details.
English
7