Bnf Transmitter Setup; Transmitter And Receiver Binding - Blade Inductrix Fpv+ Rtf Bedienungsanleitung

BNF Transmitter Setup

If you are using a computer transmitter, set the model type to "Acro" or
"Airplane" mode. In the channel input menu, set channel 6 (Aux1) to
a momentary switch such as the bind button ( I ) and channel 5 (Gear)
to a 3-position switch (switch B). In the Servo Setup menu, reverse
channel 6 (Aux1).
Bind the quadcopter to your transmitter following the Transmitter and
Receiver Binding directions below.

Transmitter and Receiver Binding

General Binding Procedure (BNF
1. Disconnect the flight battery from the quadcopter.
2. Set the model type in your transmitter settings to "Acro" mode.
3. Center all trims on your transmitter.
4. Power off the transmitter and fully lower the throttle.
5. Connect the flight battery in the quadcopter. All of the LEDs on the
aircraft will flash rapidly, indicating the aircraft has entered bind mode.
6. Put the transmitter into bind mode while powering on the transmitter.
7. Release the bind button/switch after 2–3 seconds. The quadcopter
is bound when all of the LEDs on the aircraft turn solid.
8. Disconnect the flight battery and power the transmitter off.
)
®
15
EN