Blade INDUCTRIX FPV+ RTF Bedienungsanleitung Seite 11

The USB battery charger (EFLC1013) included with your aircraft has been
designed to safely charge the 1S 3.7V 500mAh 25C Li-Po fl ight battery.
NOTICE: Inspect the battery to make sure it is not damaged e.g., swollen,
bent, broken or punctured. Charge only batteries that are cool to the touch
and are not damaged.
1. Insert the charger into a USB port. The charger only uses power from
the USB port. USB power supplies, such as those used to charge cellular
phones, can also be used.
2. Connect the battery to the
charger as shown in the
illustration above. When
you make the connection successfully, the LED on the charger turns solid
red, indicating charging has begun. Charging a fully discharged (not over-
discharged) 500mAh battery takes approximately 60 minutes. The LED
goes out when the charge is complete.
CHARGING (Solid Red LED)
MAX CHARGE (LED OFF)
3. Always disconnect the fl ight battery from the charger immediately upon
completion of charging.
CAUTION: Once charging is complete, immediately remove the
battery. Never leave a battery connected to the charger.
SOLID RED LED
–Charging
USB Li-Po
LED OFF
Charger –Charge
Complete
DC Input:5.0V 500mA
EFLC1013
DC Output:4.2V 500mA
11
EN