Herunterladen Diese Seite drucken

Silvercrest 330186 1907 Bedienungs- Und Sicherheitshinweise Seite 26

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
˜ Operation
˜ Filling the water tank
m
DANGER! Risk of electric shock! Before
filling the water tank 2 : Disconnect the power
plug 7 from the mains socket .
m
CAUTION! Fill the water tank 2 with tap water
or distilled water without any additives .
If your tap water is hard: Use distilled water .
If your tap water is moderately hard: Mix distilled
water and tap water (ratio of 1:1) .
NOTES:
As long as there are steam and pressure in
 
the water tank 2 you cannot open the safety
valve 3 . To open the water tank:
Release steam or
wait until the product has cooled down .
Do not exceed the water tank's 2 maximum fill
 
capacity of 250 ml .
Slowly open the safety valve 3 . Before fully
 
opening, wait a few seconds until the steam stops
hissing .
Use the measuring cup 13 and the funnel 11 to
 
fill the water tank 2 through the water inlet 2 .
Close the safety valve 3 .
 
˜ Turning on/off
Connect the power plug 7 to a suitable mains
 
socket .
The power indicator 18 lights up . The product
 
starts to produce steam immediately .
The product is ready to use when the steam
 
indicator 17 lights up .
Turning off the product: Disconnect the product
 
from the mains socket .
NOTES:
The product takes around 3 minutes to preheat .
 
The product has to be unplugged
 
after use,
before cleaning, and
before maintenance .
˜ Child safety lock
(Fig . A, C)
This product is equipped with a child safety lock 4 :
Child safety lock
Activate
Fully push in the
 
(position: )
the child safety lock 4 .
The steam trigger 5 can now
 
no longer be pressed down .
Deactivate
Fully push in the
 
(position:
)
the child safety lock 4 .
The steam trigger 5 can now
 
be used again .
˜ Steaming
m
WARNING! The product has to be maintained
in an upright position
while being used,
under pressure or
filled with water .
Hold the product by its handle 6 .
 
NOTES:
Controlling the steam output: Gradually press the
 
steam trigger 5 .
Stop steaming when the steam indicator 17 goes
 
off . Wait until the steam indicator 17 lights up
again . You may now resume with the work .
If there is no steam output – although the steam
 
indicator 17 is on: Disconnect the power plug 7
from the mains socket . Refill the water tank 2 .
symbol of
symbol of
GB/IE
25

Werbung

loading

Diese Anleitung auch für:

Sdr 1100 c3