Ardo CALYPSO PRO Gebrauchsanweisung Seite 4

en
3. Intended use
The Calypso Pro breastpump is intended to be used by lactating women to express and collect milk from their breast. It can
be used as a single pump and as a double pump. The unit is intended for indoor use only and is intended for multiple users.
Indications: The Calypso Pro makes it possible to feed breast milk to babies, who cannot be breastfed for a variety of reasons,
e.g. suction problems. In addition, breastpumps can provide relief from symptoms of engorgement, breast inflammation or
sore nipples and can be helpful in the case of inverted or flat nipples.
Contraindications: None known, when the unit is used for the correct purpose.
4. Start-up / Operation
For assistance in setting up, using or maintaining the breastpump please contact the point of sale or authorized
service personnel.
4.1 Controls
Stand-by switch
4.2 Preparing the pump for use
Mains operation:
• Insert the unit plug (h) of the power adapter (g) into the electrical
connection socket (i) of the unit (Fig. 1). The power adapter must
correspond to the local mains electricity supply.
Important: remove the batteries before plugging the unit into
the mains.
Battery operation:
• Release the latch (Fig. 2) and slide open the battery cover.
• Six LR 06 / AA batteries are required for use. Check the
+ / – mark orientation of the batteries (Fig. 3).
• Close the battery compartment cover and secure by re- engaging
the latch (Fig. 4). The average working life with a medium
vacuum and cycle setting is approximately 5 hours (Duracell
batteries). We recommend that you use Duracell batteries.
Connecting the pumpset
The pumpset is an applied part of Calypso Pro. Use of the pumpset
(b) is detailed in the separate "Ardo Pumpset" instructions for use.
• To use the single pumpset: attach the tube connector (c) to the
pump (f) (Fig. 5). The second opening of the tube connector
remains closed.
• To use the double pumpset: Open the second opening of the tube
connector and attach the second pumpset (Fig. 6).
• Attach the tube connector (c) to the pump (f) (Fig. 7).
4
Adjust the suction strength / vacuum (V) Change the suction frequency / cycles (C)
1
3
5
2
4
6
7