Leica LMD6500 Bedienungsanleitung Seite 17

• From above, set the stage clamp onto the
dovetail guide (3.2) and push the stage down-
wards until the upper end of the dovetail guide
is tightly fastened to the upper end of the stage
clamp.
• Firmly tighten the stage clamp (3.1).
Again, use the ball-headed screwdriver for the
scanning stage.
Fig. 4
Microscope stand with stage bracket and motorized conden-
ser
1 Stage securing screw
2 Condenser height adjuster
3 Connection for motorized condenser
1
2
3
Fig. 6
Scanning stage with motorized collection device
1 4-fold tube holder with PCR tubes
1
6. Description and assembly of the components
• In the case of the scanning stage, the securing
screw must be screwed in as well (4.1).
• Slide in the collection device as far as the stop
(fi g. 5, 6, 7).
In the case of the scanning stage, the stage
must be moved to its foremost position fi rst.
Fig. 5
Motor stage with motorized collection device
1 4-fold tube holder with PCR tubes
Fig. 7
Inserting the motorized collection device into the scanning sta-
ge. The stage must be moved to its foremost position fi rst.
1
17