Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Troubleshooting Guide
If you have followed the instructions, and are having difficulty operating your cassette receiver and remote control, locate the Symptom in the left column
below. Check the corresponding Possible Cause and Corrective Action columns to locate and remedy the problem.
|
Symptom
Possible Cause
Corrective Action
No sound. The STANDBY
The cassette receiver's AC power cord is not
Check AC power cord connection.
indicator and the clock display
plugged in properly.
do not light.
Defective fuse.
Contact your dealer.
Faulty connection of the speaker cables.
Connect the cables firmly to the speaker terminals.
The VOLUME control is set to its minimum
Turn up the VOLUME control.
position.
.
The VOLUME LEVEL indicator is flashing.
Press the remote control's MUTING button again, or press
the remote contro!l's VOLUME UP button.
:
:
Stereo headphones plug is inserted into the
Disconnect the stereo headphones piug from the PHONES
PHONES jack.
jack.
Faulty connection of one speaker cable.
Connect the cable firmly to the speaker terminal.
The BALANCE control is set fully to one side.
Reset the BALANCE control to its center position.
The POWER switch on the component
Set the POWER switch on the component to on.
connected to the cassette receiver's
SWITCHED AC outlet is set to off.
The batteries in the remote control are weak,
Check the battery potarity (+ and
—).
or are not installed properly.
Replace the batteries.
The remote control is not aimed at the infrared
Aim the remote control at the infrared sensor window.
sensor window.
An incorrect frequency has been preset.
Preset the correct frequency.
Set the ST/MONO button to MONO (ST/MUTE indicator off).
The antenna is not positioned for the best
Change the position of the antenna.
reception.
Refer to the "Antennas" section.
received.
A humming noise during AM
broadcast reception can be
loop antenna.
The tape heads are dirty.
Clean the heads.
The display, the VOLUME
LEVEL and FUNCTION
indicators light but no sound (or
very weak sound) is heard.
Sound is heard from only one
speaker.
The connected component
cannot be switched on and off
with the remote control.
The cassette receiver does not
respond to the remote control.
No reception even when a
STATION button is pressed.
Poor FM reception.
The power cord may be too close to the loop
Position the power cord away from the antenna line and the
antenna or the antenna wire.
Playback is distorted.
Poor treble sound.
NOTE:
Werbung
