Multi-Function Button - Me Bell-520 Rx Betriebsanleitung

LEGEND
1 = Wireless Doorbell BELL-520 RX (Mains operated)
2 = Wireless Doorbell BELL-521 RX (Battery operated)
3 = 230V / 50Hz power plug
4 = Battery compartment (3x 1.5V type AA alkaline)
5 = Control LED
6 = Plus button
7 = Minus button
8 = Multi-function button (Pairing / Mode switch / Reset)
9 = Illuminated ring / Speaker
COMMISSIONING
Plug the receiver into a socket or insert the batteries correctly into the bat-
tery compartment (depending on the model you own).
By default, no transmitter is paired, and the receiver automatically enters
learning mode, indicated by rapid blinking of the illuminated ring. Learning
mode is automatically exited after 30 seconds.
Within this time, press your wireless doorbell transmitter. The receiver will
then play a melody and be ready for use.

MULTI-FUNCTION BUTTON

With the multi-function button (M button), the receiver's mode can be
selected, additional transmitters can be paired, or a factory reset can be
performed.
Mode Switching
Press the M-button briefly once to switch modes.
The following options are available:
• Only illuminated ring as ringtone
• Only melody as ringtone
• Melody and illuminated ring as ringtone
15
BELL-520 RX
ENGLISH
BELL-521 RX
GB