Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use +
and –
[
6 ]
[
8 ]
o
temperature . The set temperature flashes
on the display
. The display
[
5 ]
continuously once the selected temperature is
reached .
The following temperatures are recommended
o
depending on the type of hair:
Type of hair
Bleached/lightened hair
Fine and colour‑treated hair 100 to 140 °C
Normal natural hair
Strong and resistant hair
˜ Styling the hair
NOTES:
Do not touch the scalp with the triple‑barrel
waver
and the hot barrels
2 ]
[
The hair must be clean, dry and free from
styling products . This excludes special
products that support the styling .
Comb the hair thoroughly before styling .
Use the product in a well‑ventilated room .
Wait until the hair has cooled down before
brushing or combing it . Otherwise the result
might not be satisfactory .
1 . Put the styling glove
for styling the hair .
2 . Section off a strand of hair (approx . 4 cm
wide) .
3 . Press the finger rest
triple‑barrel waver
˜ Troubleshooting
Problem
The product is not working .
to adjust the
lights up
[
5 ]
Recommended
temperature
100 to 140 °C
140 to 160 °C
160 to 200 °C
.
[
12 ]
onto the hand used
[
13 ]
to open the
3 ]
[
.
2 ]
[
Possible cause
The mains plug
connected to a socket‑outlet .
The socket‑outlet is defective .
4 . Put the strand of hair on the hot barrels
5 . Release the finger rest
the triple‑barrel waver
6 . Hold the strand of hair in the product for
approx . 5 to 8 seconds (depending on the
hair type) .
7 . Press the finger rest
triple‑barrel waver
hair .
If necessary, repeat the above steps until the
result is satisfactory .
8 . Switch off the product once the styling is
completed .
9 . Remove the mains plug
outlet . Allow the product to cool down
completely in a well‑ventilated location and
out of the reach of children .
10 . Remove the styling glove
˜ Automatic switch‑off function
NOTES:
The product is fitted with an automatic
switch‑off function . After approx . 30 minutes
the product switches off automatically . The
display
goes out .
[
5 ]
Switch the product back on to continue using
the product .
The automatic switch‑off is a safety function
only .
The automatic switch‑off function is not
intended as a replacement for switching the
product off properly .
Action
is not
Connect the mains plug
[
9 ]
socket‑outlet .
Try a different socket‑outlet .
12 ]
[
slowly to release
3 ]
[
.
2 ]
[
to open the
3 ]
[
. Carefully remove the
2 ]
[
from the socket‑
[
9 ]
from the hand .
[
13 ]
to a
9 ]
[
GB/IE
.
21
Werbung
