Assembly, General - Gressel grepos-5X Betriebsanleitung

_________________________________________________________________________________________

19.5 Assembly, general

Carry out assembly in the reverse order.
For the assembly it is important to ensure that the sealing rings are correctly inserted into the
fixed jaw and the spindle. Apply adequate lubrication to all components during assembly.
Torques:
Fixed jaw M12 x 45 12.9 screws: 120 Nm
Fixed jaw M12 x 20 NK 8.8 screws: 65 Nm
Cover M6 x 10 NK 8.8 screws: 10 Nm
www.gressel.ch
Removing the fixed jaw
 Release 4 x cylinder screws M12 x 45
 Release 2 x cylinder screws NK M12 x 20
 Remove the fixed jaw
Replacing the fixed jaw
 Align the fixed jaw with the outside of the base
plate
 Insert the four M12 x 45 cylinder screws and two
M12 x 20 cylinder screws in crosswise sequence
Tighten screws (for torque, see below)
XND.00015.001 – 03/2013 26