DYNAFIT BOOTS RADICAL Bedienungsanweisung Seite 5

slip into the boot (4). Just a bit before the count down is finishing, take out the first boot
and leave the second one on the machine. Place the footbed (if needed) back into the
boot before stepping in. Place your foot into the boot helping you with a shoehorn. Close
the boot into downhill mode to a level of medium tightness. Remain in a stable standing
position and wait at least 10 minutes to allow the liner to cool down and walking on the
heels in the first 10 seconds. Repeat these points for the second boot. External abrasion
on Thermoformable liners is normal. In the boot box, special patches are provided to
reinforce your liners if you start to see abrasion occurring on the outside of the liners.
CARE AND MAINTENANCE OF YOUR DYNAFIT BOOTS:
• Use only mild soap and water to clean your boots.
• If the liners are wet, remove them from the shells. Take out the footbeds and place
them in a warm, dry place. Keep them away from direct heat sources, such as radia-
tors, fireplaces, or ovens, as this may cause damage or change the fit.
• Before storing your boots, make sure that the liners and shells are dry. Fit the liners
into the shells, lightly close buckles and then store boots in a dark, dry place, away
from any sources of direct heat. Ideally, store your boots in the original box, or a box
whose internal surface is white, in order to prevent the lignin contained in the card
from transferring to the shell. This is especially necessary if the boots are white or
light-coloured.
• With time and sun exposure, the coloration of the boots may change. Especially the
white color could become less bright. To preserve the color of your boots we suggest
that you store them in their box or in a place protected from direct sunlight.
WARRANTY POLICY:
Dynafit guarantees its boots against manufacturer and material defects for (1) one year
from the date of purchase. Dynafit does not recognize any other expressed or implied
war- ranties. Under specified circumstances, Dynafit will replace or repair the product
at their sole discretion. The buyer should return the clean and dry boots to the place of
purchase with proof of purchase. The warranty will be recognized only for boots used
in normal conditions and will not cover any damages resulting from normal wear and
abrasion (i.e. on the outsole), misuse, disassembly, or product alteration.
LIMITATION OF THE WARRANTY:
In no event will Dynafit be considered responsible for any direct or indirect damages per-
taining to the use of the boots including loss of boots, compromising external properties,
or any other economic loss. Some States do not allow warranty duration limitation or
exclusion of direct or indirect damages so the above limitation may not apply to you.
1) 2) 3) 4)