e
•
Even if the unit has been cleaned before leaving the factory, we strongly recommend using a soft cloth dampened
in warm water with a little neutral detergent to clean it again. Then wipe it with a dry, soft cloth. (Notice: Electrical
components can only be wiped with a dry cloth)
•
Warning: Never immerse the appliance in water. Do not turn on the appliance when it is wet.
•
The appliance is intended for indoor use only, never expose it to moisture.
•
Protect the appliance and cord from heat and moisture.
•
A qualified technician must install the power supply on the boat.
•
WARNING: Do not use the appliance if it is visibly damaged.
•
Only a qualified service technician may repair this appliance. Improper repairs can lead to danger.
•
If the appliance's power cord is damaged, it must be replaced by the manufacturer, a service center, or similarly
qualified person to avoid danger.
•
It is recommended to use the appliance on a level surface and at an inclination of less than 30° when switched on.
•
When transporting, do not tilt the appliance more than 30°, handle the product with care.
•
If the appliance is tilted more than this, always leave it switched off for 24 hours before switching it on.
•
Your appliance requires good ventilation, you must ensure that there is free space for air circulation at the back (200
mm) and at the side (100 mm) of the appliance.
•
Do not place the appliance near open flames or heat sources (heaters, direct sunlight, gas ovens, etc.) - Risk of
overheating!
•
Place the unit in a dry and well-ventilated place away from heat sources (such as stoves, hot smoke, etc.) and avoid
direct sunlight.
•
Always ensure sufficient ventilation so that heat does not build up during operation.
•
Do not cover ventilation openings.
•
Ensure that the voltage is within the correct range for the cable and connection. The unit's technical data plate
shows the exact voltage ranges.
•
WARNING! Before turning on the unit, make sure the cable and plug are in good working order.
•
NOTE! Connect the appliance as follows:
- Using a 12/24 V cable to a vehicle socket (e.g. cigarette lighter).
- Using a 230 V adapter with cable to a standard 230 V socket.
- Check that the power supply parameters on the rating plate correspond to those on the mains supply.
•
WARNING! Disconnect the appliance from the mains before cleaning, maintenance and after use.
•
DANGER! Do not touch the cables with bare hands. This applies especially when the appliance is powered from
230 V electricity. 230 V mains.
•
Do not pull on the cord when disconnecting it from the power outlet.
•
If the appliance is connected to a 12/24 V socket: disconnect the refrigerator and other electrical appliances from the
battery before connecting the charging device.
•
If the appliance is connected to a 12/24 V outlet: unplug the appliance or turn it off when you turn off the motor. Oth-
erwise, the battery may be discharged.
•
Store food only in its original packaging or suitable containers.
•
Do not fill the inner container with ice or liquids.
•
Do not keep any electrical appliances in the refrigerator as they may be damaged.
•
Do not store any flammable items such as sprays in the appliance.
•
The refrigeration appliance is not suitable for transporting corrosive substances containing solvents.
•
Warning: Do not allow children to play with the refrigerator (for example, climbing or standing on the refrigerator).
They could damage the refrigerator and seriously injure themselves.
•
Electrical appliances are not toys. Keep and use the equipment out of the reach of children.
•
Persons (including children) with limited physical, sensory or mental abilities, or without sufficient experience in oper-
ating household appliances, must not operate it without the supervision of a responsible person.
Instructions for environmental protection
LIQUIDATION:
Electrical appliances should not be disposed of with municipal waste.
According to Directive 2002/96/EC on waste electrical and electronic equipment
(WEEE/WEEE) and related national legislation, electrical waste must be separated
and recycled. Recycling as an alternative to disposal: the owner of the electrical equipment is
must take the equipment to a collection point or ensure that it is properly recycled.
E-waste may be disposed of at a waste collection point operated in accordance with
the applicable national waste directives.
This does not apply to accessories without electrical components.
Safe operation of the equipment
-19-