DNIPRO M PS-30S Originalbetriebsanleitung Seite 20

en
Operation
Securely hold the power tool and lift it
to the surface of the material being pro-
cessed so that the supporting base with
the attached sanding sheet makes even
contact with the material surface.
To achieve an optimal surface finish, main-
tain a constant movement of the power
tool with a consistent speed across the
material surface without changing the an-
gle of the power tool's base relative to
the material surface. The power tool can
be moved in any direction during the sur-
face processing.
10. CARING FOR YOUR POWER
TOOL
Your power tool is designed to work for
long periods of time with minimal main-
tenance. The service life and reliability of
the power tool depend on proper care
and timely cleaning. For regular equip-
ment usage, it is recommended to per-
form maintenance procedures at least
once a month.
WARN ING!
To prevent injuries, turn off the
power tool and disconnect it from
the power source before installing
or removing accessories, making
adjustments or changes, as well as
before performing cleaning.
Ensure that the power switch is in
the OFF position. Accidental activa-
tion of the power tool can lead to
injury.
Cleaning the power tool
The sander constantly generates dust, so
it is important to regularly perform dust
and debris removal both inside and out-
side the power tool. For effective clean-
ing, direct the airflow to the following ar-
eas:
– Ventilation openings on the baseplate.
– Openings on the body of the sanding
machine.
– The opening where the dust collection
bag is attached.
– The dust collection bag itself (be care-
20
ful not to damage the seams of the bag
as excessive pressure can cause them
to tear). Avoid beating the bag against
a hard surface as it may compromise its
integrity.
To clean the power tool from dust, it is
also recommended to use brushes with
soft synthetic or natural bristles (not in-
cluded in the kit).
WA RN IN G!
Blow away dirt and dust from the
housing using dry compressed air
whenever you notice a buildup of
dirt inside and around the ventila-
tion openings. Perform the cleaning
while wearing eye and respiratory
protection.
Never use solvents or other aggres-
sive chemicals to clean non-met-
al parts of the power tool. These
chemicals can deteriorate the prop-
erties of the materials used in these
parts. Instead, use a cloth damp-
ened with water and mild soap.
WA RN IN G!
Do not allow any liquid to enter the
interior of the power tool. Under no
circumstances should you immerse
any part of the power tool in liquid..
11. TECHNICAL SERVICING OF THE
POWER TOOL
Unless otherwise expressly provided for
in this manual, the product must be ser-
viced only by the manufacturer (DNIPRO
M LLC), the DNIPRO-M authorised service
centre or the seller of the product.
Servicing carried out by unqualified per-
sonnel can cause damage to the power
tool and result in injuries.
Always maintain cleanliness of the venti-
lation openings. In addition to replacing
carbon brushes when worn, it is neces-
sary to perform service maintenance at
a service center. This extends the service
life of the power tool and ensures its con-
stant readiness for operation.
Use only components and spare parts of
the DNIPRO-M brand. Parts, the replace-
EU-PS0823001-0823001