Herunterladen Diese Seite drucken

Safety Rails; Spare Parts; Steam Generator; Heater Control - NARVI Combi Installation Und Betriebsanleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

– Covering the stove will cause a fire hazard.
– Do not place any objects top over the heater or
dry clothes near by the heater.
– Door and window must be closed when using
the heater.
– The stainless steel casing may change its color
because of the heat, which is normal behavior
for the material. Color changes are not covered
by the warranty.
– Use normal domestic water for steam water.
Do not use sea water (or other salty water) or
chlorinated water.
– Sea air and a humid climate fastens the corro-
sion of the heater.

8. SAFETY RAILS

– Safety guard 157190 (sold separately) can be
installed on the heater. In other cases, it is very
important that the minimum safety distances of
the heater are be followed.

9. SPARE PARTS

Kiuas (kW)
Vastukset
1,2,3,4,5,6
Malli
1500 W, 163576
Höyrystin
2000 W, 163577

10. STEAM GENERATOR

– This heater is equiped with the steamer unit.
Steamer unit contains watertank and heating
element. Element heats water until the desired
humidity is reached. Steaming unit can be used
same time with normal sauna heating.
– Be careful when using steaming, hot steam may
cause burning injuries.
– Water tank volume is 8 liter and heating power is
2000W.
– Always fill the tank full before using the
heater! Fill the tank before starting the heat-
ing when heater is cold.
– Use only clean water without any aromas or
scents.
9
10,5
1,3,5
2,4,6
1500 W, 163576
2000 W, 163575
2000 W, 163577
– The water tank can be drained by opening the
valve, placed behind the drain hatch. (Fig. 4)
– Remember to close the valve before using the
heater again, so that the water does not run out.

11. HEATER CONTROL

– If you want to use the steam feature of the
heater, the controller must support this feature.
– The controller suitable for the sauna and steam
functions of Narvi Combi is Narvi Dual ND105.
– Narvi Dual has two temperature sensors:
1. Sensor I (temperature measurement and
overheat protection) placed above the heater.
2. Sensor II (temperature and humidity meas-
urement) placed above the sauna benches.
CHECK THE DETAILED LOCATIONS OF THE
SENSORS IN THE CONTROLLER'S MANUAL!
– More info about Narvi Dual https://narvi.fi/
Figure 4. Steamer
15

Werbung

loading