Assembly; Preparation; Required Tools; Assembling The Grill - tepro 1066 Bedienungsanleitung

Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
BBQ's stability.
– Check the stability of the screws prior
to each use. If necessary, tighten all of
the screws again to ensure the BBQ is
standing securely.
Attention Risk of damage!
Do not use any strong or
grinding solvents or abrasive
pads, since these can attack
the surfaces and leave behind
scrape marks.

Assembly

Preparation

Danger Risk of injury!
Failure to follow these instruc-
tions can lead to problems and
risks while using the grill.
– Follow all of the assembly instructions
listed here.
1. First read through the entire assembly
instructions.
2. Allow yourself enough time for assem-
bly and find an even working space of
two to three square meters.
3. Small parts such as handles will prob-
ably be pre-assembled.
4. Look out for sharp corners and wear
protective gloves for assembly.

Required tools

1 x Phillips screwdriver
1 x Adjustable spanner
P170060_TEPRO_1066_Vista_K_DE_GB-20170831.indb 19

Assembling the grill

1. Unpack the grill
Unpack the grill and dispose of all
packaging materials. Keep the pa-
ckaging materials out of the reach of
children and dispose of them accor-
ding to regulations after grill assem-
bly.
2. Notes on screws and nuts
All the parts are held together with
M5x12 screws (A) and M5 nuts (B). In
total, 26 screws and nuts are required
for assembly. During assembly, stick
the screws through the openings from
outside, so that the nuts are on the
inside.
3. Attaching the stand column to
thestand foot
Place the stand column (7) over the
retaining plates on the stand foot (9)
and fix it in place with four M5x12 (A)
screws and M5 nuts (B).
4. Sliding the ash drawer into the
stand column
Slide the ash drawer (8) into the
opening at the base of the stand
column (7).
t
19
31/8/2017 3:11 PM