Assembly; Preparation; Required Tools; Assembling The Bbq - tepro ATLANTA Bedienungsanleitung

– Always be attentive and aware of what
you are doing. Do not use this product
if you are unfocussed or tired, or if you
are under the influence of drugs, alco-
hol, or medications. Just one moment
of carelessness during use of the prod-
uct can lead to serious injuries.
Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
BBQ's stability.
– Check the stability of the screws prior
to each use. If necessary, tighten all of
the screws again to ensure the BBQ is
standing securely.
Attention Risk of damage!
Do not use any strong or
grinding solvents or abrasive
pads, since these can attack
the surfaces and leave behind
scrape marks.

Assembly

Preparation

Danger Risk of injury!
Failure to follow these instruc-
tions can lead to problems and
risks while using the BBQ.
– Follow all of the assembly instructions
listed here.
1. First read through the assembly
instructions completely.
2. Allow yourself enough time for as-
sembly and find an even working
space of one to two square meters.
3. Small parts such as handles will prob-
ably be preassembled.
4. Look out for sharp corners and wear
protective gloves for assembly.
P180209-TEPRO_Atlant_00299-1_K_DE_GB_20181114.indd 15

Required tools

1 x Phillips screwdriver
1 x Adjustable spanner

Assembling the BBQ

Unpack the grill and dispose of all pa-
ckaging materials. Keep the packaging
materials out of the reach of children and
dispose of them according to regulations
after grill assembly.
1. Fix the bottom shelf (3) with srews (A)
and nuts (B) between the short and
lomg legs (2+4).
2. Insert the axle (5) through the large
lower openings at the end of the short
legs (2), attach the wheels (1) and fix
with plastic washers (C) and locknuts
(D).
3. Place the fire bowl (7) on the legs (2
+ 4). Screw the left side of the fire
bowl (7) with screws (A) and nuts (B)
to the legs (2) and tighten loosely.
Loosely secure the fire bowl (7), long
legs (4) and side shelf (9) with the
screws (A) and nuts (B).
4. Slide the lower rim of the left wind
shield part (6) under the fire bowl (7)
and fix with screws (A) and nuts (B).
Slide the lower rim of the right wind
shield part (8) under the fire bowl
(7). Insert the rear wind shield part
(11) into the fire bowl (7). Fix the rear
windscreen part (11), the fire bowl
(7) and the left and right windscreen
parts (6 + 8) with screws (A) and nuts
(B) screw.
5. ATTENTION: Fasten all screws.
t
15
14/11/2018 10:10 AM