tepro 1066 Bedienungsanleitung Seite 20

t
5. Assembling the funnel-shaped fire
bowl
Join the four elements for the fire
bowl (6) one after another using a
total of eight M5x12 screws (A) and
M5 nuts (B). Tighten the screws only
by hand.
6. Assembling the windshield and
attaching it to the fire bowl
The right (2) and the left windshield
(3) are bent at the back and are
placed behind the rear windshield (1).
Join the right, left, and rear wind-
shields with the M5x12 screws (A)
and M5 nuts (B). Attach the assem-
bled windshield using the screws and
nuts to the elements of the fire bowl
(6). Tighten the screws only by hand.
20
P170060_TEPRO_1066_Vista_K_DE_GB-20170831.indb 20
7. Attaching the fire bowl to the
stand column and inserting the
charcoal plate
Place the completely assembled
fire bowl with windshield on top of
the stand column with the open side
pointing forward (same position as
the ash drawer and ventilation con-
troller). The lower retaining plates on
the fire bowl must sit inside the stand
column (NOT outside of it!). It is pos-
sible the plates will have to be bent a
little with a pair of pliers so that they
sit inside the stand column. Fix the
fire bowl in place on the stand column
using four screws and nuts. Finally,
tighten all of the screws and nuts on
the fire bowl and on the windshield.
Place the charcoal plate (5) in the
middle of the fire bowl.
31/8/2017 3:11 PM