Assembly; Unpacking; Assembling The Fire Pit - tepro Copper Mountain Bedienungsanleitung

– Always wear oven or BBQ gloves when
grilling. (Glove Category II with regard
to heat protection, e.g. DIN-EN 407)
– Wear proper clothes. Long, loose
sleeves can easily catch fire!
– Wear sturdy, closed shoes. Sandals do
not provide any protection against hot
charcoal pieces!
– Never leave open fire and ember unat-
tended. Risk of injuries and fire!
– Always have a bucket of sand ready
for extinguishing fires in case of emer-
gency.
– Put the remaining charcoal and ashes
into a non-flammable metal container
and then fill this container to the top with
water. Leave the charcoal and water in
the metal container for 24 hours before
disposal.
– Only use well-dried wood (storage pe-
riod of at least 3 years) or commercially
available briquettes.
– Never use the fire pit as a barbecue.
– Take into consideration your neighbors,
so smoke or odors will not disturb them
and their property does not get endan-
gered.

Assembly

Unpacking

Hazards for children!
Children may become
entangled in packaging foil
and suffocate.
– Never let children play with packaging
foil.
– Make sure that children do not place
any small assembly parts in their
mouth. They could swallow small parts
and suffocate.
P180158-TEPRO_01391_CopperMountain_Feuerstelle_DE_GB_20180815.indd 15
All manuals and user guides at all-guides.com
• Unpack the device and check for com-
pleteness.

Assembling the fire pit

Note:
Assemble the fire pit as illustrated. All
screw nuts must be installed on the
inside of the fire pit.
First connect all parts, connectors,
screws and nuts loosely. After assembly
of all parts, tighten all screws and nuts.
Danger! Risk of cuts!
Sheet metal parts can have
sharp edges. Be cautious dur-
ing assembly.
1. Installing the legs
Attach the legs (7) to the small ring (5)
using the screws (9) and nuts (10).
2. Installing the large ring
Attach the large ring (6) to the legs (7)
using the screws (11) and nuts (10).
3. Inserting the fire bowl and fire
grate
3a. Place the fire bowl (4) onto the
small ring.
3b. Place the fire grate (3) inside
the fire bowl (4).
3c. Attach the ring handle (1) to
the spark screen (2) using the nut.
3d. Place the spark screen (2) on
the fire bowl (4).
Important: Tighten all screws.
t
15
15/8/2018 12:36 PM