Installing And Integrating - Eq-3 Rst-2 Bedienungsanleitung

EN
All manuals and user guides at all-guides.com

Installing and integrating

1. Disassemble the mechanical thermostat by turning
it to the left as far as it will go. Unscrew the union
nut until you can remove it from the thread.
Wait until the pin is fully retracted and A1 appears
2.
on the display. When the pin is fully retracted A2
appears on the display.
3. Now install the radiator thermostat. It fits all stand-
ard valves with an M30 x 1.5 mm connection thread.
You will need adapters for some heater valves.
Adapters for Danfoss valves in the RAV, RA and
RAVL series are inclu ded.
4. Briefly press the button on the radiator thermostat
to start the self-adjustment process. A3 will appear
on the display. This procedure can take up to three
minutes. If the procedure is aborted, F2 will appear
on the display. You can restart the procedure by
pressing the button again.
5. Integrate the device via the search mode of the user
software in the SmartHome.
You can find tips and tricks for installation at:
https://service.startsmarthome.de/radiator-thermostat/installation
16