Appliance Description; Instructions, Standards And Regulations; Standard Delivery; Accessories - STIEBEL ELTRON DNM 3 Bedienung Und Installation

INsTALLATIoN

Appliance description

7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
The specific electrical resistance of the water must not fall below
that stated on the type plate. In a linked water network, factor in
the lowest electrical resistance of the water (see chapter "Speci-
fication / Data table"). Your water supply utility will advise you of
the specific electrical water resistance or conductivity.
8. Appliance description
8.1

Standard delivery

The following are delivered with the appliance:
- Sieve inside the cold water inlet
- Special aerator "SR"
- Company logo for oversink installation
8.2

Accessories

Special aerator "SR"*
- SR 3: Part number 289591
for DHM 3 and DHM 4
30 | DNM
- SR 5: Part number 270582
for DHM 6 and DHM 7
* For use in thread M22/M24.
Non-pressurised taps
- WEN Sensor tap for washbasins
- MAW Wall mounted tap for oversink installation
- MAZ Twin-lever basin tap
- MAE Mono lever basin tap
ZTA 3/4 - central thermostatic valve
Thermostatic valve for central premixing, for example for operat-
ing an instantaneous water heater with a solar thermal system.
9.

Preparations

f Flush the water line thoroughly. f
Water installation
No safety valve is required.
Taps/valves
f Use suitable taps (see chapter "Appliance description / f
Accessories").
www.stiebel-eltron.com