Care And Maintenance; Warranty Disclaimer; Service And Support - Hama EWS-800 Bedienungsanleitung

• In the individual maximum and minimum value display, press the SET button (28) for approx. 3 seconds to
delete the corresponding values with the date (21) and time (24) they were recorded.
• Press the SNOOZE / LIGHT button (32), or wait for approx. 20 seconds to return to the display of the
current measurement values.
Note – Replacing the batteries
Note, the stations have to be resynchronised each time after you change the batteries in the measuring
or base station. To do this, remove the batteries from the other station and then reinsert them, or change
them as required.
Note – Faulty transfer of measured values
In isolated cases, interference—e.g. from a WLAN network, a computer or a television set—can cause the
transfer of measured values between the measuring station and the base station to fail.
In this case, you must resynchronise the stations by briefly removing the batteries from both stations and
reinserting them.
If the measured values are not transferred again once the batteries are inserted, replace the batteries with
new ones.
If necessary, select a new location for the base station in order to avoid possible interference in the future.

7. Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.

8. Warranty Disclaimer

Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.

9. Service and Support

Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
13