Filling The Water Tank - MPM MKD-04M Bedienungsanleitung

FILLING THE WATER TANK

1. Make sure that the ice cube maker is unplugged from the mains.
2. Lift the lid (3), remove the ice cube bucket (10), and fill the water tank (5) with no more than 1.2 litre
of water at an ambient temperature. Do not spill the water on the housing.
CAUTION! Do not fill the water tank over the max water level. Use clean potable water only.
3. Install the ice cube bucket (10) and make sure that
the level of water in the tank is below the bottom
of the ice cube bucket (10).
4. Close the lid (3).
USING THE ICE CUBE MAKER
1. Having properly positioned the ice cube maker and
filled it with water, plug it into the mains. The ice
cube maker POWER indicator (4e) will be flashing.
2. Press the ON/OFF button (4a) - the ice maker will
start the ice making process and the POWER indi-
cator light (4e) will light up continuously. Use the SELECT button (4b) to select the size of the ice
cubes you receive:
- (S) - small ice cubes
- (L) - large ice cubes
3. The machine will produce 9 ice cubes every 6-8 minutes depending on the size of the cubes.
However, this time may also vary slightly depending on the ambient temperature and pressure.
Typically, the first cycle of the device may be slightly longer. If the room temperature is lower than
15°C, it is recommended to choose a small ice cube to prevent the ice from sticking together.
4. Inspect the ice cube making process through the viewport (2). When the ice cube bucket (10) is
completely filled with ice cubes, the ICE FULL indicator (4b) will light up. Remove the ice cube
bucket (10), store the ice cubes in a cool place and put the ice cube bucket (10) back in the ice
cube maker. The ice cube maker can be restarted again right away to make more ice cubes. If you
do not remove the ice cubes in time, they will ultimately melt and the water will flow back to the
water tank.
5. If the water tank (5) is empty, the ADD WATER (4c) indicator will light up. Turn off and unplug the
ice cube maker from the mains and add water.
CAUTION! The first symptom that the ice cube maker may require more water is the decreasing
volume of each ice cube. This depends on a number of factors.
CAUTION! After refilling the water, wait at least 3 minutes before restarting the unit - this is the
time needed for the refrigerant to stabilize.
6. To stop making ice cubes, press the ON/OFF switch (4a). The POWER indicator (4e) will start
flashing; the ice cube maker stopped running and is ready to resume. Unplug the ice cube maker
from the mains.
7. If you do not need to use the ice cube maker in the next few hours, remove the unused water.
Place a suitable container under the water drain plug (9), and remove the rubber seal. When the
water stops flowing out, place the rubber seal back in.
CAUTION! Add and drain water only with the power cord unplugged from the mains!
EN
12