MPM MKD-04M Bedienungsanleitung Seite 11

EN
range specified below, depending on the climate class shown on
the nameplate. The appliance may malfunction if kept outside
the specified ambient temperature range for a long time.
SN (extended – moderate)
N (moderate)
ST (subtropical)
T (tropical)
ICE CUBE MAKER OVERVIEW
1. Ice cube maker housing
2. Viewport
3. Water tank and ice cube bucket lid
4. Control panel
a. ON/OFF button
b. cube size selection button
c. lack of water indicator light (ADD
WATER)
d. cube container full indicator light
(ICE FULL)
e. power indicator light (POWER)
BEFORE FIRST USE
1. Unpack the ice cube maker and remove all plastic bags, labelling stickers, filling materials and trans-
port locks.
2. Inspect for transport damage. If you suspect that the ice cube maker is damaged, do not use it.
Consult the seller.
3. Install the device holder - the holder can only be installed in the holes in one correct position. Once
the handle is installed, it can be moved freely.
4. Place the ice cube maker on a firm, dry and stable surface, away from sources of heat and direct
sunlight, to maximize its performance. Keep a clearance of 10 cm minimum around the ice cube
maker to provide proper ventilation.
CAUTION! Do not use the ice cube maker outdoors.
CAUTION! Do not use the ice cube maker at extremely low or high temperatures. If the ambient
temperature is below 10°C or above 43°C, making ice cubes will be difficult.
5. Before using the ice cube maker, leave it at the room temperature for at least 1 hour after delivery.
The ice cube maker needs this time to reach the ambient temperature and stabilize its refrigerant.
If you move the ice cube maker, wait at least 60 minutes before turning it on.
6. Verify that your power mains match the nameplate ratings of the ice cube maker. Plug the ice cube
maker to power outlets with a PE terminal only.
7. The ice cube maker makes ice cubes intended for human consumption. You need to clean the ice
cube maker before the first use, see Section "CLEANING AND MAINTENANCE".
11
+10°C to +32°C
+16°C to +32°C
+18°C to +38°C
+18°C to +43°C
f. small cube production indicator
light (S)
g. large cube production indicator
light (L)
5. Water tank
6. Ice cube dispenser
7. Ventilation grille
8. Power cord
9. Water drain plug
10. Ice cube bucket
11. Ice cube scoop
12. Device holder