Network Setup - SKYTRONIC 351.124 Anleitung

5.21 Network Setup

Network Setup allows you to prepare the DVR for viewing over the internet or local
network.
IMPORTANT: This setting should only be changed if multiple DVRs are being setup on the same
network and the first code "00" must not to be changed.
MAC ADDRESS: In a local area network(LAN)，
the MAC (Media Access Control) address is your
computer's unique hardware identity code.(On an
Ethernet LAN，it is the same as your Ethernet
address.)When you are connected to the Internet
from your computer (or host as the Internet
protocol thinks of it )， a corresponding table relates
your IP address to your computer's physical
(MAC) address on the LAN.
IP ALLOCATION: DVR supports DHCP and
Static IP modes. If your modem/router supports
DHCP mode use DHCP. When using STATIC
mode, you will be required to setup your internet
settings manually.
Note: After setting the DVR to DHCP mode restart
the unit.
IP Address: In a local network, the IP
address is a unique designated address for your
DVR recognized by your router. Ensure this
number is within the range usable by your
modem/router. Use the UP "▲"and DOWN "▼"
buttons to move the cursor and use the
"SELECT" button to change the numbers. Once
you have finished the changes restart your DVR.
13
User Manual