General Information; Use Of Ventilators/Fans - HEYLO TD 300 Bedienungsanleitung

1. General information

CAUTION: Read carefully before starting up !
Please observe the notes in the operating instructions carefully. In case of non-observation, the
warranty claims will become void. The manufacturer shall not be liable for any damage and/or
consequential damage resulting.
Introduction This section includes general information on the device and on the manual.
Target group The manual is intended for service engineers installing the device, carrying out
maintenance work and changing defective parts.
Copyright Copying the manual, as a whole or in parts, is only permitted with the written
approval of HEYLO GmbH!
Conditions HEYLO GmbH reserves the right to make changes and improvements to the
product and manual without prior announcement or notification.
Disposal The device is designed for long term operation. If it has to be disposed of, this
must take place in accordance with the respective legal regulations in an
environment friendly manner.
Safety instructions!
Keep out of reach of children: Do not allow children to play with the device or near the device.
Electrical connection: Fans and ventilators are designed for operation at 230V/50Hz. Use only with a
plug with earthing contact! Sockets used must be earthed and have to save by a fault current
protection switch.
Protect power cable from damage: Never use the device with a damaged power cable. If the power
cable is damaged, it must be replaced by a cable of the same type and dimensions.
Extension cable: Only used approved extension cables!
Handle with care: Do not drop or throw the device since this could lead to damage of components or
wiring.
Place on a steady surface: Always place the device on a steady, even surface.
Make sure it is fixed in place during transport: Tie down the device during transport to prevent it
from slipping and sliding.
Keep it dry: The device cannot be operated in puddles or stagnant water. Do not store or operate it in
open spaces. If the electric wiring or parts of the device get wet, dry it thoroughly before using it again.
Keep the air vents free: Do not cover or block the air inlets and outlets.

2. Use of ventilators/fans

The fans are designed in such a way that they blow air over moist surfaces to dry them quickly. They
are particularly suitable for drying floors, since they produce a flat air column. A high volume air flow
increases evaporation, helps prevent the formation of mould and mildew and reduces the risk of
additional damage caused by moisture. Flowing air improves evaporation since it blows away the film
of saturated air on the boundary, lying above wet surfaces.
9
EN