Dmx-Mode; Dmx-Protocol - Futurelight PRO Slim PAR-12 QCL RGBW/RGBA Bedienungsanleitung

DMX-Mode

The device has three different DMX channel modes. The Control Board allows you, as described above, to
assign the DMX channel mode.
Addressing
Press the MODE-button until the display shows Addr. You can now set the desired address via the UP or
DOWN buttons. Press ENTER to confirm. The Control Board allows you to assign the DMX fixture address,
which is defined as the first channel from which the FUTURELIGHT PRO Slim PAR-12/PAR-18 QCL
RGBW/RGBA will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each FUTURELIGHT PRO
Slim PAR-12/PAR-18 QCL RGBW/RGBA correctly and independently from any other fixture on the DMX-
chain.
If several PRO Slim PAR-12/PAR-18 QCL RGBW/RGBA are addressed similarly, they will work
synchronically.
Controlling:
After having addressed the PRO Slim PAR-12/PAR-18 QCL RGBW/RGBA, you may now start operating it
via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show "d001." with the actually set address. If there is no data received at the
DMX-input, the display will show "d001" with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

10 channel mode
Control-channel 1 - Dimmer
Decimal Hexad. Percentage
0 255 00 FF
Control-channel 2 - Red
Decimal Hexad. Percentage
0 255 00 FF
Control-channel 3 - Green
Decimal Hexad. Percentage
0 255 00 FF
Control-channel 4 - Blue
Decimal Hexad. Percentage
0 255 00 FF
Control-channel 5 – White or Amber
Decimal Hexad. Percentage
0 255 00 FF
S/F
0% 100% F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
0% 100% F Red (0=off, 255=100% red)
S/F
0% 100% F Green (0=off, 255=100% green)
S/F
0% 100% F Blue (0=off, 255=100% blue)
S/F
0% 100% F White or amber (0=off, 255=100% white/amber)
Feature
Feature
Feature
Feature
Feature
27/31 00070049.DOC, Version 1.1