Werbung
Verfügbare Sprachen
Verfügbare Sprachen
solder side of the 15 PIN or 25 PIN D-Sub connector (as shown in the picture above).
STEP 5: Set the speed dome camera at the DVR side.
Go to the "REMOTE" menu to set the speed dome camera.
a) Select the device to "PTZ".
b) Set the ID to the value the same as the one set in the speed dome camera. The default ID of the
camera is 000.
c) Select the protocol based on the speed dome camera you're connecting.
d) Set the baud rate to the value the same as the one set in the speed dome camera. The default baud
rate of the camera is 2400.
TITLE
CH1
CH2
CH3
CH4
PLEASE CONSULT YOUR INSTALLER FOR ADVANCE SETTING
SELECT
3.4 Power Setup
This device should be operated only with the type of power source indicated on the manufacturer's label. Connect
the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED "
green. It takes approximately 10 to 15 seconds to boot the system.
Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply, for continuously operation. (Optional)
3.5 Date and Time Setting
Before operating your DVR, please set the date and time on your DVR first.
Press the "MENU" button and enter the password to go to the menu list. The default admin password is 0000.
Move to "DATE" and you can set the date / time / daylight saving in the "DATE" menu list.
Note: Please DO NOT change the date or time of your DVR after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it's recommended to clear all HDD data, and start recording again.
Note: For the first time to use the DVR, please charge the DVR for at least 48 hours continuously after the
date & time is set correctly.
3.6 Password Setting
Press the "MENU" button and enter the password to go to the menu list. Then, move to "ADVANCE" to enter the
advanced setting menu.
In the "ADVANCE" menu, move to "SYSTEM". Select "PASSWORD" and press the "ENTER" button to enter the
submenu to set the password (four digits). The default admin password is 0000.
REMOTE
DEVICE
ID
PTZ
000
CAMERA
000
CAMERA
000
CAMERA
000
BACK
NEXT
PROTOCOL
NORMAL
NORMAL
NORMAL
NORMAL
ENTER
-10-
CONNECTIONS AND SETUP
RATE
2400
2400
2400
2400
" will be on as
Werbung
