Surveillance Systems 4CH MPEG4 DVR Bedienungsanleitung Seite 12

3.2 Camera Connection
The cameras must be connected and power-supplied BEFORE the DVR is turned on. The DVR will automatically
detect the video system of the connected camera(s) (NTSC / PAL), and switch itself to the correct system.
Note: For detailed DVR video input / output ports, please refer to "2.2 Rear Panel" at page 5.
For detailed camera operation, please refer to its own manual.
Note: If you want to make a video backup with audio, please connect audio camera to the CH1 which
support the audio function
3.2.1 Camera Connection
1) Power connection:
Connect the camera with indicated power supply.
2) Video cable connection:
Connect the camera video output to the DVR video input port with a coaxial cable or RCA line with BNC
connector.
3) RS485-A & RS485-B wires connection (For speed dome camera only):
Solder the RS485-A (brown) and RS485-B (orange) wires of the PTZ camera to the corresponding pins on the
solder side of the 15 PIN D-Sub connector. For details, please refer to "3.3.3 Speed Dome Camera" at page 9.
4) Camera Setup (For speed dome camera only):
For detailed camera title, ID, protocol and baud rate setup, please refer to "7.3 REMOTE" at page 22.
3.3 External Device Connections
3.3.1 VGA Converter Connection (Optional)
This optional peripheral allows your DVR to have VGA output function. For the connection method, please refer to
the following figure as an example (do not use gender changer). For detailed connection, please refer to your VGA
converter manual.
3.3.2 IR Transmitter
Please connect the IR receiver line to the IR port on the DVR rear panel. And make sure the IR function is
(Model 3, 4 & 5 only)
-8-
CONNECTIONS AND SETUP