Miganeo Speed Clean 7000 Bedienungsanleitung Seite 30

2
3. Mount the drainage screws set
4. Insert the screen
6
5. Position the screen in the center of the filter vessel bottom.
6. Fill the filter vessel
2
4
7. Attach the centering device
screen.
8. Fill the filter vessel with quartz filter sand or filter balls
Please refer to the section "Technical data" for the required quantities.
9. Remove the centering device from the opening of the filter vessel.
Store the centering device for the next filling.
6
10. Guide the vessel seal
11. Place the valve head on the filter vessel.
12. Align the valve head so that the "PUMP" connection points towards the future position of the pump
(see illustration in the section "Mounting the pump on the base plate").
13. Place the locking ring
30
on the drainage opening
8
in the filter vessel .
2
approximately 1/3 with water.
to the opening of the filter vessel so that it centers the pipe of the
7
over the bottom of the valve head
4
around the valve head and filter vessel connecting point.
5
3
.
17
5
.
16
7
.
1