Before Use - Dreame Ultra Benutzerhandbuch

Before Use

Connect to an Electrical Outlet

Insert the power cord into the base station and plug it into the socket. Place the
base station in a location that is as open as possible with a good Wi-Fi signal.
Note: When using the robot for the first time, accompany it during cleaning to promptly
address any potential obstacles.
Positioning and Installing the Base Station Ramp Extension
Plate

Clear any objects within 1.5m in front and 5cm on either side of the base station.
Subsequently, install the base station ramp extension plate onto the base station.
Note: It is recommended to place the base station on tile floors or marble floors.
Remove the Protections

Remove the two stickers from the front and back of the robot, and then lower the
robot cover to remove the protective strip.
Turn on the Robot and Install the Side Brush and Mop
Assembly

Press and hold the On/Off Button on the robot for three seconds to turn it on. Install
the side brush and mop assembly into place.
Connect the Robot to the Base Station

Place the robot onto the base station with the mop assembly facing towards the
washboard. You will hear a voice prompt indicating a successful connection
between the robot and the base station.
Note: It is advisable to fully charge the robot before its initial use. If the robot cannot
be turned on after the battery is depleted, manually connect the robot to the base
station to initiate the charging process.
Install the Cleaning Solution Bottle

Remove the cap of the cleaning solution bottle and tear off the two seals on the
bottle. Open the upper cover of the base station and install the bottle along the slot
into place. The cleaning solution will be added automatically while the robot is in
operation.
Note: Only use the officially-approved cleaning solution; adding any other liquid may
result in base station malfunction.
Add Water to the Clean Water Tank

Remove the clean water tank from the base station, and fill it with clean water up
to the max water line. Then reinstall it back into the base station.
Note: Avoid adding hot water to the water tank as it may cause deformation.
12