Husqvarna BGS 250 Bedienungsanweisung Seite 16

1. Connect the dust extractor to the product. Use a 50
mm hose.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
level ground when you do maintenance.
WARNING:
from the power supply before you do
maintenance.
WARNING:
cool before you do maintenance. The motor
General product maintenance
Clean the product. Refer to
Do a check of all safety devices. Refer to
product on page 8 .
Make sure that nuts and screws are tight.
Clean the electrical enclosure.
Do a check of the electrical components, the cables and the
connections for wear and damages.
Do a check of the hose connections. Do a check of all hoses on
the product for damages or leakage.
16
Maintenance
Before you do
The product must be on
Disconnect the power plug
The product must become
To clean the product on page 17 .
Safety devices on the
2. Make sure that the filters in the dust extractor are
clean and not damaged. Monitor the dust during the
operation.
becomes very hot during operation and
there is a risk of burn injuries.
For all servicing and repair work on the product,
special training is necessary. Husqvarna guarantees
the availability of professional repairs and servicing. If
your dealer is not a service agent, speak to them for
information about the nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Daily maintenance
Daily maintenance means that you clean the product.
Also that you do a check of the electrical supply,
grinding head and the grind holder.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
Daily
X
X
*
*
*
*
Each 3
Weekly
months
2363 - 002 - 12.03.2024