Lamp Adjustment - Futurelight Pro-Head-Spot PHS-260 Bedienungsanleitung

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the fixation screws A and B of the lamp system and carefully remove it from the
housing.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder.
Step 4: Replace the lamp system in the housing and tighten the fixation screws.
Step 5: Adjust the lamp as described under lamp adjustment.

Lamp adjustment

If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "1, 2, 3" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Do not operate this device with opened cover!
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, open the shutter, set the dimmer intensity
onto 100 % and direct the light towards a flat surface
(wall). Center the hot-spot (the brightest part of the beam)
using the 3 adjustment screws "1, 2, 3". Turn one screw
at a time to drag the hot-spot diagonally across the
projected image. If you cannot detect a hot-spot, adjust
the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three
screws "1, 2, 3" clockwise ¼-turn at a time until the light
is evenly distributed.
39/116 00020952.DOC, Version 1.6