Panasonic EY7412 Bedienungsanleitung Seite 14

There is a possibility of malfunction in a location with excessive
electromagnetic waves, such as close to high voltage wires.
E
Disconnect this unit once and reattach when a malfunction has
N
occurred.
LED Light [Fig.4]
The light is turned on linked to the separate push switches.
*Flashing is overload protection
The LED light illuminates when the switch is pressed.
The LED light will turn off when the switch is released (switch off).
CAUTION:
Do not use it as a substitute for a regular flashlight, since it does
not have enough brightness.
CAUTION: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radia-
tion exposure.
Charging status lamp
Illuminated in red - Charging
Illuminated in green - Charge completed
Flashing in red - Battery out of charge
Bit-locking Function [Fig.5]
To Use as a Hand-turning Screwdriver.
There is a hand tightening function.
Turn this unit by hand.
Use with 8 Nm (82 kgfcm) or less.
Do not use forceful removing as a box driver (M6 bolt or larger).
How to charge [Fig.6]
1) Securely connect the supplied USB socket cable to the USB
socket of this unit.
2) Connect the other end of the USB socket cable to a chargeable
USB port.
* Use an USB port with 5 V rating on an AC adapter, a PC,
mobile battery, etc.
*Available to charge with EY37C4, EY37C5, EY37C6.
3) Make sure to remove the USB socket cable once the charging
is completed.
- 14 -