Panasonic EY7412 Bedienungsanleitung Seite 12

WARNING
E
• Do not use the charger with DC power supply, engine generator,
N
or transformer.
• Do not use the LED light as a torch.
• Do not use this unit when soiled with foreign matter such as oil.
• Securely insert the supplied USB socket cable all the way in.
• Periodically remove the dust, etc., on the supplied USB socket
cable.
• When operating in high locations, check that there is nobody
below, and secure this unit with a wire, etc., so it will not fall.
• Immediately disconnect the USB socket cable when abnormal
sound, abnormal heating, or abnormal odour is emitted from this
unit, and request inspection and repair at the dealer.
• Securely attach the tip tools such as the bits or accessories
following the Operating Instructions.
• Take cautions of the small diameter bits since they are easy to
break.
CAUTION
• Do not store this unit in a location that exceeds 50°C.
• Do not use this unit with excessive force that the motor locks.
• Do not touch the USB socket with a wet hand.
IV. ASSEMBLY
Attaching or Removing Bit [Fig.1] [Fig.2]
NOTE:
Do not use this unit with excessive force that the motor almost
stops.
Stop the operation when this unit gets hot, and use after it has
cooled down.
This unit is equipped with quick connect chuck.
1. Hold the collar of quick connect chuck and pull it out from the
driver.
2. Insert the bit into the chuck. Release the collar.
3. The collar will return to its original position when it is released.
4. Pull the bit to make sure it does not come out.
- 12 -