Werbung
Verfügbare Sprachen
Verfügbare Sprachen
_ 1. The dishwasher was thoroughly tested
before leaving the factory. Traces of small
water spots may still_ be present.
;
They will disappear the first time the
machine is used.
. Dismantling the appliance
~ Pull-out the plug.
~ Turn off water fap.
~ Detach hoses from water tap and studs
of drainage pipe syphon.
~- Unscrew and remove mounting screws
from under the work top.
— If applicable, remove kick strip.
_~ Pull appliance out so that the hoses drag
behind.
. To transport appliance, ensure that it is
placed either in upward position or flat on
_ its back. If transported otherwise, any
residual water found in the. appliance may
'get to the control units and adversely
influence the functioning of the prgrammes.
. For comparative purposes only -
arrangement according to IEC 436
standards.
Capacity: 7 place settings
Arrangement: Fig. & and 3
Comparative programme : Normal 65° C.
Amount of dishwasher cleanser used in
the test study: 15 g.
Se
5. Interference suppression:
interference suppression as established
_
by the 82/499/EWG regulations.
. Applies only to appliances fitted with
»Wasserstop".
The ,Wasserstop" is a safety device. The
»Wasserstop" assures that the fresh water
hose need only take the stress of water
pressure during the actual time water is
flowing. If the hose should begin to leak
during this time, the magnetic valve in the
water spout cuts off the flow, and the hose
is relieved of pressure.
N.B.
:
:
When laying hose observe that it remains
below the lower edge of the ,Wasserstop"
box.
'
Incorrect hose laying can adversely
—
influence the function and safety factor of
the system.
Before releasing the ,Wasserstop" unplug
appliance or disengage fuse and turn off
water tap.
.
Do not submerge .,Wasserstop" in a water
filled container (e.g. wash basin, tub or
bucket).
-_
:
23
in
Werbung
