Bauknecht GCF 2152 Gebrauchsanweisung Seite 18

in order to work well, the dishwasher needs.
soft water. The dishwasher is equipped with a
built-in water hardness regulator. The regulator
must be correctly. set so that it can soften
hard water. 7
' How to adjust the water
hardness regulator
Before using the appliance for the first time
adjust water softener with the help of a coin.
Your local water board will tell you
_ what the water hardness in your area
is. '
Hardness range
4
2-3
'Water hardness ,
°dH > 28 10-21
mmol/l >5,0° 1,8-3,8
'gently. The fill operation is to be
Filling the regenerating salt
'container
Fig.
Use only regenerating salt intended
for household dishwashers!
Before using the dishwasher for the first time,
fill approximately one liter of water into the
regenerating salt container.
To fill container with regenerating salt, —
open container's lid; this is found on the
inner left-hand side wall of the
'.dishwasher, between the upper and the
lower baskets.
To open, press down on lid's latch °
(Fig. €2/22).
The inner side of the lid is fitted with a
small dosifying cup. Remove cup and fill
with regenerating salt. The cup has a
capacity of approximately 250 g.
Replace filled cup on lid and close lid
repeated twice.
We suggest using either fine or coarse
regenerating salt. Never use table salt, cooking
salt, defrosting salt, road salt or large salt
tablets. These types of salt generally contain
insoluble substances which, in the long run,
would adversely influence the function of the -
water softening system. ;
Salt should be added just before the
running of programme 2-3, so that
tub will be rinsed out with hot water.
Salt-refill indicator
Fig. €3/8
In the case of areas with a high degree
of water hardness, refill salt reservoir
as soon as the refill indicator lamp -
goes on.
In the case of areas with very soft .
- water (<<10° dH/1,8 mmol/}), ignore the
refill indication.
15