Bauknecht GCF 2152 Gebrauchsanweisung Seite 23

ana the S pnliaiee on
-— Check that the rotating arms
(Fig. 23/12 and 23/14) can turn
freely all the way around.
If necessary, remove any obstacles.
— Close the door.
— Turn water tap on fully.
— Index programme selector
. (Figure €3/1) to the desired
programme. The figure is set at
starting position (Figure €3/2); turn
selector only clockwise.
~ If applicable, press the button
--corresponding-to-the-desired——¥————
programme (Figure 3/6). :
- = Press main switch (Figure <2 15),
the pilot light goes on (Figure om,
and the programme starts.
If the programme selector (Fig. any is
turned 360° clockwise, the detergent
container will open. If it is full at the time,
the detergent will be released
into the machine too soon.
Detergent must then be added again
before washing.
Turning off the appliance
~ Press main switch to OFF position
(Figure €)/5).
Pilot lamp will go out (Fig. 2/7).
- Turn off the water tap.!
The programme selector need not
be reset. ;
Programme sequence indicator
The symbols stand for the following washing'
phases:
4 Pre-rinse or intermediate rinse
A\\ Wash
HE Final rinse
SY Drying
The programme sequence indicator moves .
during the programme to show the particular
washing phase taking place during a washing
cycle.
interrupting the programme — -
If the programme needs to be interrupted,
press the main switch (on/off) button
(Fig. @/5).
Push the same button again for the
programme sequence to continue.
If the dishwasher is connected toa hot water
Supply, or if the programme is interrupted after
the dishwasher has heated the water, allow
door to lean for a few minutes before
reclosing.
20