Texas 90062059 Bedienungsanleitung Seite 16

4. Assembly of the machine
5. Gasoline and oil.
Before inserting the adjustable height shaft into the edger, make
sure it is fully extended.
Carefully guide the bottom of the extended shaft into the base of
the edger, taking care not to kink or catch the operating cable.
Lining up the holes in the shaft with the location holes in the base
of the edger.
Insert the bolt through the base and secure it tight.
Check the throttle is operating correctly before you start the edger.
Mount the handle (press it down) and tighten it.
You can adjust it in the position/angle that suits you best.
Use unleaded gasoline octane 95.
Use 2-stroke oil. Mix gasoline and oil 50:1 (2%), if you use
Tex-Parts 2-stroke oil (spare part no. 90306480). All other
types of 2-stroke oil should be mixed 40:1 (2,5%). Use a con-
tainer designed for the purpose. Never mix directly into the
tank.
Never tank with the engine running or when it is hot.
If you spill fuel it must be wiped off before starting the engine.
Move the machine away from where you tanked before star-
ting it.
www.texas.dk
15