Tools For The Drum; Trouble Shooting - Contec CT 200 Betriebsanleitung

12
3.1
4

Tools for the drum

Tools for the CT 200®
Parameter
Drum diameter
Cutter shaft diameter
Number of shafts
TCT cutter
Milling cutter
Beam flail
Cutter diameter
Max No. of TCT cutters
Max. No. of milling cutters

Trouble Shooting

Trouble Shooting
Problem
Machine does
not run
High dust
development
during operation
High vibration
Value
10.8 cm
1.2 cm
4
46/5
46/20
46
4.6 cm
76
24
Possible cause
– Power supply interrupted
– Defective fuse cable or
plug defective
– Connection to the dust
collection system inter-
rupted
– Extraction system not
switched on
– Milling area sealing de-
fective
– Wear & tear parts are
worn out
tRoUble shootInG
Solution
– Check the network supply
– Eliminate the fault by a spe-
cialist or replace parts
– Check dust port connection
– Turn on or restart dust coll-
ector
– Replace sealings
– Check all tools and the cor-
rect assembly of drum and
replace if required