Correct Position Of The Cutters In The Drum; Adjusting The Tool Drum - Contec CT 200 Betriebsanleitung

8
2.5
2.6

Correct position of the cutters in the drum

Danger!
Excessive depth adjustment will jam the cutters between the drum shaft and the
surface (A). The consequence is the destruction of the cutters, drum shafts and the
drum. If the machine has to be lowered, always make sure that the tools can still
turn freely on the drum shafts (B).
Correct position of the cutters in the drumutters Position A und B.
Danger!
Excessive depth setting reduces the power of the tools and does not improve per-
formance.

Adjusting the tool drum

Adjusting the tool drum
1 Rear wheel swing
2 Eccentric shaft
3 Clamping screw
4 Screw
During the operation of the CT 200® floor planer or after a drum has been changed or re-
placed, the drum shaft and the rear wheel axis can fall out of alignment. This is noticeable
through an uneven milling pattern.
The CT 200 machine touches down earlier on one side than on the other and thus removes
more material on this side. One of the two rear wheels is mounted on an eccentric shaft.
(see picture above - adjusting the tool drum)
oPeRat InG the MaChIne